Hazmat Placards Practice Test
Updated October 2026 · Reviewed by Ken, instructor · FMCSA-registered training provider since 2023
Quiz 5 of 10 · 16 questions · free, no sign-up. This quiz checks what you know about hazmat placards: when you need them, which ones to use, and where they go on the truck. Rather watch? Take our 30-question video practice test on YouTube.
Need your hazmat endorsement? Take our free ELDT hazmat class — pay $69 only after you pass.
Hazmat Placards Test Answers and Explanations
1. What is a placard on a trailer for?
Answer: To tell others about the hazard of the load
Placards warn police, firefighters and other drivers about the danger of the hazmat inside.
Rule: CDL manual, Section 9
2. What do you need to know to decide which placards to use?
Answer: The hazard class, how much of it you have, and the total weight of all hazmat on the truck
Placards depend on the hazard class, the amount of each material, and the total weight of all hazmat classes on board.
Rule: 49 CFR 172.504
3. When do Table 1 materials need placards?
Answer: Any amount
Table 1 materials are so dangerous that any amount needs placards.
Rule: 49 CFR 172.504(e) (Table 1)
4. When do Table 2 materials need placards?
Answer: When the total weight is 1,001 pounds or more
Table 2 materials need placards once all of them together weigh 1,001 pounds or more.
Rule: 49 CFR 172.504(c)(1)
5. Which materials does the 1,001-pound exception NOT cover?
Answer: POISON INHALATION HAZARD or DANGEROUS WHEN WET
Inhalation hazard and dangerous when wet loads need placards for any amount, so the 1,001-pound exception never applies.
Rule: 49 CFR 172.504(c)
6. You have 1,001 pounds or more of two or more Table 2 hazard classes in non-bulk packages. When may you use DANGEROUS placards instead of separate placards?
Answer: When you have not loaded 2,205 pounds or more of any one Table 2 material at one place
DANGEROUS may replace separate Table 2 placards unless 2,205 pounds or more of one material was loaded at one place.
Rule: 49 CFR 172.504(b)
7. You are hauling Division 1.1 and Division 1.3 explosives. Which placard do you use?
Answer: EXPLOSIVES 1.1 only
When explosives of more than one division are loaded, you show only the placard with the lowest division number.
Rule: 49 CFR 172.504(f)(1)
8. The words INHALATION HAZARD are on the shipping paper or package. What placards do you need?
Answer: POISON GAS or POISON INHALATION HAZARD placards, plus any other placards the load needs
Inhalation hazard materials need POISON GAS or POISON INHALATION HAZARD placards on top of other required placards, for any amount.
Rule: 49 CFR 172.505(a)
9. A material also has a hazard of being dangerous when wet. What placards do you need?
Answer: DANGEROUS WHEN WET placards, plus any other placards the load needs
A dangerous when wet secondary hazard needs DANGEROUS WHEN WET placards on top of the other required placards.
Rule: 49 CFR 172.505(c)
10. How many placards must a placarded vehicle have, and where do they go?
Answer: Four, on both sides and both ends of the vehicle
Placards must be on both sides and both ends, so a placarded vehicle has at least four identical placards.
Rule: 49 CFR 172.504(a)
11. When must placards be put on the vehicle?
Answer: Before you drive it
A carrier may not move a hazmat vehicle until it is placarded, so placards go on before you drive.
Rule: 49 CFR 177.823(a)
12. How far must a placard be from other markings, such as ads?
Answer: At least 3 inches
A placard must be at least 3 inches away from any marking that could make it harder to see.
Rule: 49 CFR 172.516(c)(4)
13. What is the shape and size of a placard?
Answer: A diamond at least 9.84 inches (250 mm) on each side
Placards are diamonds (squares turned on a point) at least 9.84 inches, or 250 mm, on each side.
Rule: 49 CFR 172.519(c)(1)
14. What goes in the bottom corner of a placard?
Answer: The hazard class or division number
The hazard class or division number is shown in the bottom corner of each placard.
Rule: 49 CFR 172.519(b)(4)
15. When may you show placards that are not required?
Answer: When the placard shows the real hazard of the load and meets all placard rules
You may placard a load even when not required, as long as the placard matches the real hazard and follows the rules.
Rule: 49 CFR 172.502(c)
Next quiz: Quiz 6, Hazmat Cargo Tanks & Bulk Practice Test
Keep studying: take the full hazmat practice test, read the Hazmat Guide, or start the free hazmat course.
